Tiger 1200 Handguard Extensions

Drill THREE 4mm holes in each Hand Guard as shown roughly in the picture.


Align the extension pieces in the position you require then make a slight fold where it starts to narrow to make sure it fits into the corner.


Once you are happy with their position, mark the required front 2 hole positions in the extension pieces - remove and carefully drill two 4mm holes.


Attach the front 2 fixings then mark the side fixing location - remove again and drill a 4mm hole.


Install all the fixings with the fomer-tabs positioned on the inside.


Ensure a washer is fitted on the inside of the other locations and the nuts are secure but do not overtighten.

With the extension pieces fully installed you can now bend the former-tabs until the required angle is achieved

(as shown above).