Bar Ends - Buell XB - Installation:

Firstly, unclip the handguards and remove the end plugs.

Slacken off the centre bolt in the bar-ends so there is a gap of 3-4mm as shown.

Insert the bar-ends as far as they will go, whilst maintaining the gap.

Snap the handguards back onto the centre bolt by using the gap.

Tighten the centre bolt just enough to apply securely fasten the whole assembly.


The bar-ends are made from raw material so apply a regular coating of polish or similar to prevent corrosion, etc.


Remember to allow for the extra width of the handle-bars.